河北压接机厂

压接机的使用注意事项

Points for attention in the use of press splicer

1、使用前检查压接机的端子是否正确，面板螺丝是否松动

1. Check whether the terminal of the press is correct before use, and whether the panel screw is loose

2、电源供电是否安全可靠

2. Is the power supply safe and reliable?

3、先单打、并经拉力测试压接是否可靠，直至达标后再连打。

3, first singles, and tension test whether the pressure is reliable, until the standard, and then beat.

4、工作结束后需清扫工作台，并检查刀排是否完好，如有异常需及时调整或更换。

4, after the end of the work need to clean the work table, and check the knife row is intact, if abnormal, need to adjust or replace in time.