河北压接机厂

一、工作前必须按规定穿戴好防护用品。 二、工作前必须检查机床的良好状态，紧固螺钉是否有松动，模具有无裂纹，操作机构、自动停止装置、离合器、制动器、启动器、启动按钮等是否灵活可靠，滑动及转动部位必须加注润滑油 三、暴露于机床之外的转动部件，必须安装有防护罩，严禁在无防护罩的情况下开车或试车。 四、装卸模具时必须停车断电，将滑块开到下死点，模具的闭合高度必须正确，校正和行程调节必须点动慢进，滑块螺母必须紧固，尽量避免偏心载荷，模具必须紧固牢靠，并通过试压检查。

First, we must wear good protective articles in accordance with the regulations. Two, the work must be in good condition before the inspection of the machine tool, the fastening screws are loose, the mold has no cracks, operating mechanism, automatic stop device, clutch, brake, starter, start button is flexible and reliable, sliding and rotating parts must be lubricated, three rotating parts exposed to the machine outside the door must be installed no cover, drive or test in the case of no protective cover. Four, mold unloading must stop off, move the slider to the bottom dead center, die must be correct, correction and must move slowly into the stroke adjustment, slider nuts must be fastened, avoid eccentric load, the mold must be fastened firmly, and through pressure test check.