压接手势不正确或压接速度过快造成压接不良_新闻动态_压接机,端子压接机,自动压接机-河北厂家价格

新闻动态

当前位置：网站首页 > 新闻动态 > 详细信息

压接手势不正确或压接速度过快造成压接不良

添加时间：2019/11/6 15:53:59 浏览次数：

1、外皮压接过度
1. Excessive skin crimping
原因：压接手势不正确或挡板调试不当导致芯线压接部位压进线皮，造成线皮压接过度（深打）不良。
Cause: incorrect crimping gesture or improper baffle debugging result in the crimping part of core wire pressing into wire sheath, resulting in excessive (deep tapping) of wire sheath crimping.
后果：直接影响导体的压接，造成电流流通不顺或直接断路。
Consequence: directly affect the crimping of conductor, resulting in the current flow is not smooth or directly open circuit.
2、外皮压接不足
2. Insufficient skin crimping
原因：压接手势不正确或压接速度过快造成压接不良。
Cause: improper crimping gesture or too fast crimping speed cause poor crimping.
后果：由于导体和绝缘部压接均不足，造成端子的拉力不够，在产品使用过程中容易断裂，直接影响产品性能。
Consequence: due to the insufficient crimping of conductor and insulation part, the tension of terminal is not enough, and it is easy to break during the use of the product, which directly affects the product performance.
3、芯线外露
3. Core wire exposed
原因：在压接过程中，电线芯线散乱，或者压接方法不当。
Cause: in the process of crimping, the wire core is scattered, or the crimping method is improper.
后果：
Consequence:
1.露出的铜丝容易造成漏电，同时也容易接触到别的端子造成短路。
1. The exposed copper wire is easy to cause leakage, and it is also easy to contact other terminals to cause short circuit.
2.芯线压接部位由于铜丝少，间接影响端子的拉力，造成拉力不足。
2. There are few copper wires in the crimping part of core wire, which indirectly affects the tension of terminal, resulting in insufficient tension.

上一页不能贪图小便宜而购买质量比较差的静音端子机

下一页管型端子压接机怎样才能选购到比较好的