1、点检设备,检查电器与供气系统是否正常。

1, check the equipment to check whether the electrical and gas supply system is normal.

2、确认机械主体上是否搁着东西或四周是否搁放着危险的东西。

2, confirm whether the machine is on the subject or whether the dangerous things are put on or around.

3、泄放过滤调节器中的积水后开始供给空气，此时确认压力指示在0.5MPa.

3. Release the water in the filter regulator and start to supply air. At this time, it is confirmed that the pressure indicator is at 0.5MPa.

4、接通电源，启动压接机从JOG模式开始进行试运转，确认机械动作。

4, connect the power supply, start the press from the JOG mode to start the test operation, to confirm the mechanical action.

5、当试运转一切正常后，开始进行实际加工运转。

5. When the test runs all the normal, start to carry on the actual processing operation.

6、设置实际加工的电线，输进各种加工条件（剥皮电线长度，压接位置等）。

6, set the actual processing wire, into various processing conditions (the length of the peeling wire, the position of the pressure connection, etc.).

7、产品的确认：首先由操纵者对产品进行初步判定，然后交与专职检验员检验，完全合格后方可开始生产。

7, product confirmation: first of all by the manipulator to the preliminary judgment of the product, and then to the full-time inspectors inspection, fully qualified to start production.

8、当在生产过程中发生故障时，操纵者应立即关掉电源，上报主管，由专职维修职员来进行维修，切勿擅自动手。

8, when there is a fault in the production process, the operator should turn off the power immediately, report to the supervisor, and repair it by full-time maintenance staff, so don't do it yourself.

9、工作结束后切断电源、气源、清扫现场保持机器整洁（在打扫机台上切屑时严禁用气吹）。

9. After the work is finished, the power supply, the gas source and the cleaning site are kept clean and tidy.